Prev PostASTM A307
Scope
The ASTM A307 specification covers carbon steel bolts and studs ranging from 1/4” through 4” diameter. This is your everyday, run of the mill bolt specification often manufactured using A36 round bar. There are three grades A, B, and C* which denote tensile strength, configuration, and application. Refer to the Mechanical Properties Chart for the subtle strength differences within each grade.
Grades
|
A
|
Headed bolts, threaded rods and bent bolts intended for general applications.
|
|
B
|
Heavy hex bolts and studs intended for flanged joints in piping systems with cast iron flanges.
|
|
C*
|
Nonheaded anchor bolts, either bent or straight, intended for structural anchorage purposes. The end of a grade C anchor bolt intended to project from the concrete will be painted green for identification purposes. Permanent marking is a supplemental requirement. *As of August 2007, grade C has been replaced by specification F1554 grade 36. We will continue to supply grade C, if required by the project.
|
Mechanical Properties
|
Grade
|
Tensile, ksi
|
Yield, min, ksi
|
Elong %, min
|
|
A
|
60 min
|
--
|
18
|
|
B
|
60 - 100
|
--
|
18
|
|
C*
|
58 - 80
|
36
|
23
|
Recommended Nuts and Washers
|
Nuts
|
Washers
|
||
|
A307 Grades A & C*
|
A307 Grade B
|
||
|
1/4 - 1-1/2
|
1-5/8 - 4
|
1/4 - 4
|
|
|
A563A Hex
|
A563A Heavy Hex
|
A563A Heavy Hex
|
F844
|
